If you've been around mountain bikes as long as I have, you probably remember halogen bike lights. You know, the ones that sucked so much power (and turned it directly into heat) that to get more than a couple of hours of pathetic yellow light you needed a battery that replaced your water bottle? (Don't worry, if this concept is new to you, you didn't miss much).
Step 8: retake the night!
Anyway, it turns out that I have one of these monstrosities in my basement, and being a die-hard New England cheapskate, it felt wrong to throw it away for something more modern. A little internetting (yes it's a word), found these LEDs for a trivially small amount of bling, and I couldn't help but wonder if the gigantor heat-sink of old might be convertible to something usably modern.
Spoiler: it can. and Here's how...
Step 1: Cut apart the original reflector and remove the bulb (yay, DREMEL).
Step 2: Solder some wires to the original pins and epoxy everything in place (forgot pic...)
Step 3: Solder the LEDs in series on a little circuit board (I repurposed the board from an old garage door opener for this, cutting up the ground plane to make the layout I needed. This was nice for heat dissipation too (then I forgot to take a picture). Some thermal paste can be used here to make sure the board pulls heat from the LED, but it may not be necessary.
Step 4: Attach the power wires to the circuit board
Step 5: Superglue the circuit board to the old reflector, which was ground down to have a bigger opening.
Step 6: Superglue the base of the old bulb to the back of the circuit board
Step 7: Install modified bulb / reflector (with the right polarity!)
Step 8: retake the night!
Posts
